Roll crusher with teeth DVZ 2L-11

Roll crusher with teeth: special modification of DVZ 2L. It differs from the original crusher only in the length of its teeth on rotor pads and special cleaning knives. Such modification provides better catching materials and their finer crushing.

The crusher is intended for crushing materials of low and medium strength (700-1200 kgf/cm 2 ) with moisture content of up to 25%.

The roll crusher can be installed not only indoors, but also outdoors (using tents).

Roll crusher with teeth DVZ 2L-11: Technical data ***
Parameters	Values *
Design capacity, m 3 /h (gap between rotors: 15 mm)	Up to 50*
Source material particle size d н , mm (at minimum gap between rotors)	Up to 300*
Rotors RPM	150/300
Rotor diameter, mm	500
Active rotor length, mm	820
Final product particle size, mm	min: 0-15; max: 0-150 mm (95%) ****
Tooth height, mm	11
Motor power, kW	18.5; 37*
Voltage, V	380
Crusher weight, kg	3,870

* Parameters varied depending on physical properties of materials.
** Depends on requirements of customers. Final product particle size depends on a particular gap between the rotors.
*** All the values are calculated or taken on the basis of materials previously processed by this crusher.
**** The particle size can be increased by increasing the gap between the rotors.

Please find out current prices by phone +7-800-700-46-86.

The following auxiliary electrical equipment can be purchased additionally to your crusher: power switchboards, cable products, automation systems.

Dimensional and connecting drawing of the DVZ 2L roll crusher

Device of roller crusher DVZ-2L

 

Pictures of DVZ DVZ 2L-11 Roller Crusher